beautypg.com

AT&T AUDIX Networking 585-300-903 User Manual

Page 105

background image

DCP Cabling and Administration

9-15

_

______________________________________________________________________________________

_

______________________________________________________________________________________

_

______________________________________________________________________________________

6. Assign line appearances to the DCP equipment location. Make the entries as shown in Figure 9-9,

Manager II Administration for DCP Ports (Proc 052, Word 1). The extension shown in Field 8 is
only an example.

7. The first extension is assigned to Device Type 0 (Field 6) Member 0 (Field 7). Repeat step 6, only

use Device Type 0 Member 1 and assign a different extension to it.

8. Repeat steps 6 and 7 for the second DCP equipment location. Assign two other extension numbers to

Device Type 0 (Field 6) Members 0 and 1 (Field 7) for this equipment location.

If desired, you may display the extensions using Proc 052, Word 2.

ENHANCED MODE - PROCEDURE: 052, WORD: 1

MULTIAPPEARANCE TERMINAL/DATA MODULE - LINE APPEARANCE

TERMINAL EQUIPMENT LOCATION

DEVICE ID

1. Module: 0

6.

Device Type: 0 Basic Set

2. Cabinet: 1

7. Member (button): 0

3. Carrier: 1

EXTENSION APPEARANCE ID

4.

Slot: 18

8.

Extension: 32330

5. Circuit: 3

9. Line Appearance: 1

10.

Line Type: 1 Prime line

11.

Ringing Type: 1 Ringing

12.

Home Terminal: 1 Yes

13. Originating Only: 0 No

14.

SAC Group: 0 No

DISPLAY ONLY

15. Button Type: 1 Line appearance (052w1)

Connected to CC0 ON-LINE

MAJOR

MINOR

RUN TAPE

BUSY OUT

IN USE

WAIT

enter command: _

3 Data

5 Help

6 Field

7 Input

8 Cmds

Figure 9-9. Manager II Administration for DCP Ports (Proc 052, Word 1)

9. After the extensions are assigned here, their BCCOS may be reset to 1. Go back to Procedure 000,

Word 3 and check if the BCCOS is still 6. If not, reset it to 6 if necessary. Check each of the
AUDIX networking extensions.