AT&T AUDIX Networking 585-300-903 - Manual (Page 101)

DCP Cabling and Administration 9-11
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________ _ ______________________________________________________________________________________
2. Assign all four extensions (or six if you are converting RS-232 ports to DCP) to Bearer Capability
Class-Of-Service (BCCOS) 6 as shown in Figure 9-5, Manager II Administration of a DCP Port
(Proc 000, Word 3). The extension number shown is only an example.
NOTE
The default BCCOS 0 through 8 should not be modified to support AUDIX
networking. If a custom BCCOS is required, create a new BCCOS using the default
values shown in PROC 014, Words 1 and 2. Refer to the DEFINITY Generic 2
Administration Procedures manual (555-104-506) if needed.
The BCCOS 6 default parameters are also shown in Figure 9-6, Manager II
Administration of a DCP Port (Proc 014, Word 1), and Figure 9-7, Manager II
Administration of a DCP Port (Proc 014, Word 2).
ENHANCED MODE - PROCEDURE: 000, WORD: 3
SINGLE TERMINAL - MISCELLANEOUS FEATURES
1. Extension: 32330
2. Hot Line: 0 Not a hot line
3. Dedicated Switch Connection Messages: 0 Not supported (TDM, PDM, DTDM)
4. Audible Message Waiting - Automatic: 0 Disabled
5. Bearer Capability Class of Service: 6
6. Universal Code Calling ID: ---
Connected to CC0 ON-LINE ♥ MAJOR MINOR RUN TAPE BUSY OUT IN USE WAIT
enter command: _
3 Data 5 Help 6 Field 7 Input 8 Cmds
Figure 9-5. Manager II Administration of DCP Port (Proc 000, Word 3)