AT&T AUDIX Networking 585-300-903 User Manual
Page 151

DCP Mode 3 Installation and Administration
12-3
_
______________________________________________________________________________________
_
______________________________________________________________________________________
_
______________________________________________________________________________________
Using Procedure 100, Word 2, assign BCCOS 3 to the DS1 trunk group to provide 64K clear-channel
signaling (trunk group 77 is only an example).
If BCCOS 3 has been modified at your site, use a custom BCCOS that has the default values of
BCCOS 3. Refer to the DEFINITY Generic 2 Administration Procedures manual (555-104-506) for
default BCCOS values if needed.
ENHANCED MODE - PROCEDURE: 100, WORD: 2
TRUNK GROUPS - MODEM POOLING AND BCCOS
1.
Trunk Group: 77
2. Bearer Capability Class of Service: 3
MODEM POOLING
3. Originate Mode: _
4.
Answer Mode: _
5.
Modem Type: _
6.
First Choice: _
7. Test Type: _
Connected to CC0 ON-LINE
♥
MAJOR
MINOR
RUN TAPE
BUSY OUT
IN USE
WAIT
enter command: _
2 Repeat 3 Form
5 Help
6 Field
7 Input
8 Cmds
Figure 12-1. Manager II Mode 3 Administration (Proc 100, Word 2)
3.
For remote networking configurations using AAR or ARS: If the local AUDIX DCP extension is
dialing AAR or ARS to reach a remote AUDIX system, the appropriate pattern and preference must
indicate BCCOS 3 (Proc 309, Word 5, Field 6 = 3, or Proc 321, Word 5, Field 5 = 3).