Administering ports, Figure 13-3. the network port form, System – AT&T AUDIX Networking 585-300-903 User Manual
Page 172: Translation : remote updates, Form)

13-18
AUDIX System Administration
________________________________________________________________________________________________
________________________________________________________________________________________________
________________________________________________________________________________________________
ADMINISTERING PORTS
The
system : translation: network port
form only affects the local system. It is used to
administer the RS-232 channels. It is also used to activate the DCP channels and to indicate the data rate
that will be used when a DCP mode 2 call is received. Each DCP channel has its own rate. The default,
9600 bps, is typically used. The RS-232 channels cannot be equipped, but may be cabled up, if the system
is equipped with a TN366 or TN366B. The system must have the TN539 or TN539B to equip and use the
RS-232 channels.
Log in to an AUDIX administration or maintenance terminal and type
sys tra net
on the path line.
Press
RETURN
. A
system : translation : network port
form will be displayed showing
the factory default settings. The port type field shows that channel 5 and channel 6 of the TN539 or
TN539B are the RS-232 channels.
AUDIX STATUS: alarms:
, logins: 1, thresholds: none
PATH: system : translation : network port
(PRESS ENTER TO DISPLAY CURRENT MODEM INITIALIZATION STATUS)
channel 5
channel 6
port type:
rs232
rs232
equipped (y/n):
_
_
synch/asynch (s/a):
_
_
data rate (1):
_____
_____
data rate (2):
_____
_____
data rate (3):
_____
_____
switched/dedicated (s/d):
_
_
modem initialization strings:
channel 5: __________________________________________________________________
channel 6: __________________________________________________________________
modem initialization status:
channel 5: __________________________
channel 6: __________________________
DCP ports — data rate for incoming Mode 2 calls or 0 if channel is not used
channel 1: _____ channel 2: _____ channel 3: _____ channel 4: _____
Error and confirmation information appears on this line.
_
______________________________ _
____________________ _
______________________________
CHANGE ADD DELETE
HELP FIELD
CLEAR EXIT ENTER
OR RUN
HELP
FORM
_
______________________________ _
____________________ _
______________________________
Figure 13-3. The Network Port Form