AT&T AUDIX Networking 585-300-903 - Manual (Page 147)

DCP Mode 2 Installation and Administration 11-29
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________ _ ______________________________________________________________________________________
6. Using Procedure 100, Word 2, make the assignments shown in Fields 1 through 7. Assign BCCOS 5
to the trunk group (trunk group 131 is only an example). Refer to Figure 11-14, Manager II
Administration for Analog Side of Modem Pooling (Proc 100, Word 2).
NOTE
BCCOS 5 is the default and should not be modified. However, if BCCOS 5 has been
modified at your site, use a custom BCCOS that has the default values of BCCOS 5.
Refer to the DEFINITY Generic 2 Administration Procedures manual (555-104-506)
for default BCCOS values if needed.
ENHANCED MODE - PROCEDURE: 100, WORD: 2
TRUNK GROUPS - MODEM POOLING AND BCCOS
1. Trunk Group: 131
2. Bearer Capability Class of Service: 5
MODEM POOLING
3. Originate Mode: -
4. Answer Mode: -
5. Modem Type: -
6. First Choice: -
7. Test Type: -
Connected to CC0 ON-LINE ♥ MAJOR MINOR RUN TAPE BUSY OUT IN USE WAIT
enter command: _
2 Repeat 3 Form 5 Help 6 Field 7 Input 8 Cmds
Figure 11-14. Manager II Administration for Analog Side of Modem Pooling (Proc 100, Word 2)