AT&T AUDIX Networking 585-300-903 - Manual (Page 109)

DCP Mode 1 Installation and Administration 10-3
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________ _ ______________________________________________________________________________________
System 85 Administration
The following translations need to be completed for a System 85 for static switched 56 Kbps (dynamic
access is not supported for System 85 R2V3 or R2V4; System 85 R2V2 does not support 56 Kbps
networking). System 85 is administered as follows using the MAAP.
1. Using Procedure 010, Word 4, assign mode 1 data to the class of service associated with the AUDIX
networking ports (Field 3 = 1).
_ ______________________________________________________________________________________
Wd 1 2 3 4 PROC _ ______________________________________________________________________________________ _ ______________________________________________________________________________________
4 1 010 _ ______________________________________________________________________________________ 




















2. Using Procedure 100, Word 1, translate the trunk group (tgroup) as follows:
a. Assign a dial access code (DAC) in Fields 2 through 5. The dial string used by the AUDIX
networking ports must be routed via a dedicated (static) trunk group using this DAC.
b. Assign a DMI trunk type (Field 6 = 109). The DS1 facility used to transport the 56 Kbps call
must employ robbed-bit signaling.
_ ______________________________________________________________________________________
Wd 1 2-5 6 7 8 PROC
_ ______________________________________________________________________________________ _ ______________________________________________________________________________________
1 tgroup dac 109 0 0 100 _ ______________________________________________________________________________________ 























3. Using Procedure 101, set the following values:
a. Set Touch Tone In and Touch Tone Out to 1 (Fields 6 and 7 = 1).
b. Set the AVD bit for the trunk group to 0 (Field 17 = 0).
_ _____________________________________________________________________________________
Wd 1 2 3 4 5 6 7 8 - 16 17 PROC
_ _____________________________________________________________________________________ _ _____________________________________________________________________________________
1 tgroup 1 1 0 101 _ _____________________________________________________________________________________ 








































