Dcp mode 1 installation and administration – AT&T AUDIX Networking 585-300-903 User Manual
Page 112

10-6
DCP Mode 1 Installation and Administration
________________________________________________________________________________________________
________________________________________________________________________________________________
________________________________________________________________________________________________
3. Using Procedure 101, Word 1, make the assignments shown below:
ENHANCED MODE - PROCEDURE: 101, WORD: 1
TRUNK GROUP CHARACTERISTICS
1.
Trunk Group: 76
2. Balance:
0
Disabled
3.
Battery Reversal: 0
Disabled
4. Incoming Prefix Digit : -
No additional digit for DID
5. DCS:
0
Disabled
6.
Touch-Tone In: 1
Enabled
7.
Touch-Tone Out: 1
Enabled
8.
CDR Active: 0
No
9.
AIOD Billing Number: ----
TIMED RECALL
10. Time:
0
11. Level: 0
Recall occurs when recall time expires
12.
CDR Variable Timer: -- Default (procedure 275 Word 3 field 12)
13.
Pad Group: 0 Determined by trunk type in Procedure 100 Word 1
14.
Tie Toll: 0 Not toll restircted
15. APLT Features Allowed: 0 Disabled (CCSA trunk)
16. Disconnect Supervision: 0 Disabled
Connected to CC0 ON-LINE
♥
MAJOR
MINOR
RUN TAPE
BUSY OUT
IN USE
WAIT
enter command: _
2 Repeat 3 Form
5 Help
6 Field
7 Input
8 Cmds
Figure 10-3. Manager II Mode 1 Administration (Proc 101, Word 1)