AT&T AUDIX Networking 585-300-903 User Manual
Page 111

DCP Mode 1 Installation and Administration
10-5
_
______________________________________________________________________________________
_
______________________________________________________________________________________
_
______________________________________________________________________________________
2. Using Procedure 100, Word 2, assign BCCOS 7 to the trunk group (trunk group 76 is only an
example).
NOTE
BCCOS 7 is the default and should not be modified. However, if BCCOS 7 has been
modified at your site, use a custom BCCOS that has the default values of BCCOS 7
(one that uses robbed-bit signaling). Refer to the DEFINITY Generic 2 Administration
Procedures manual (555-104-506) for default BCCOS values if needed.
ENHANCED MODE - PROCEDURE: 100, WORD: 2
TRUNK GROUPS - MODEM POOLING AND BCCOS
1.
Trunk Group: 76
2. Bearer Capability Class of Service: 7
MODEM POOLING
3. Originate Mode: _
4.
Answer Mode: _
5.
Modem Type: _
6.
First Choice: _
7. Test Type: _
Connected to CC0 ON-LINE
♥
MAJOR
MINOR
RUN TAPE
BUSY OUT
IN USE
WAIT
enter command: _
2 Repeat 3 Form
5 Help
6 Field
7 Input
8 Cmds
Figure 10-2. Manager II Mode 1 Administration (Proc 100, Word 2)