AT&T AUDIX Networking 585-300-903 - Manual (Page 100)

9-10 DCP Cabling and Administration
________________________________________________________________________________________________
________________________________________________________________________________________________ ________________________________________________________________________________________________
Manager II Administration
Manager II assignments for Generic 2 are as follows:
1. Assign all four extension numbers (or six if you are converting RS-232 ports to DCP) to the system
(Proc 000, Word 1) as shown in Figure 9-4, Manager II Administration of a DCP Port (Proc 000,
Word 1). The extension number shown is only an example; use the extension numbers provided by
the BCSDC.
Use a class-of-service (Proc 010, Word 1 and Word 3) that has touch-tone dialing capability and data
protection – permanent. Class of service 10 is only an example.
ENHANCED MODE - PROCEDURE: 000, WORD: 1
SINGLE TERMINAL TRANSLATION
1. Extension or VDN: 32330
TERMINAL EQUIPMENT LOCATION
2. Module: --
3. Cabinet: -
4. Carrier: -
5. Slot: --
6. Circuit: --
7. Class of Service: 10
8. Port Type: - Extension administered in Procedure 052 Word 1
9. Disable Signaling: - Non-DS1 lines
DISPLAY ONLY
10. Recent Disconnect: 0 Extension is not in recent disconnect
11. Use the Procedure(s) Shown: 052
Connected to CC0 ON-LINE ♥ MAJOR MINOR RUN TAPE BUSY OUT IN USE WAIT
enter command: _
3 Data 5 Help 6 Field 7 Input 8 Cmds
Figure 9-4. Manager II Administration of DCP Port (Proc 000, Word 1)