AT&T AUDIX Networking 585-300-903 - Manual (Page 29)

Introduction 1-9
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________ _ ______________________________________________________________________________________
2.4 FT. (0.73M) UP TO 200 FT (60.96M)
AMPHENOL 50-PIN
FEMALE CONNECTOR PATCH TO
CROSS-CONNECT
FIELD
OR SWITCHED RS-232
ENDPOINTS
CONNECT TO DEDICATED
RS-232 25-PIN
MALE CONNECTORS
AMPHENOL 50-PIN
MALE CONNECTOR
5.0 FT (1.524 M)
ED-1E434-11 GROUP 300
50 PIN MALE-MALE
OR
ED-1E434-11 GROUP 500
50 PIN MALE-FEMALE
A
B
CONNECTS TO AUDIX
ACCE PORT
Figure 1-2. H600-331, Group 2 AUDIX Networking Breakout Cable
H600-331, Group 1 Cable
The H600-331, Group 1 breakout cable is no longer shipped; only an AUDIX system that is already
installed will have the Group 1 networking cable. One end of this cable is a 50-pin male Amphenol
connector that connects to the ACC or ACCE on the AUDIX system. The other end of the cable has two
8-pin DCP connectors and two 25-pin RS-232 male connectors. See Table 1-2 for pin assignments.
The H600-331, Group 1 DCP connector 0 provides access to two DCP channels (AUDIX networking
channels 1 and 2). DCP connector 1 also provides access to two DCP channels (AUDIX networking
channels 3 and 4). The two 451A adapters are shipped on the ends of connectors 0 and 1. The D8W-87
extension cords and 103A adapters must be ordered separately.
The H600-331, Group 1 RS-232 connector A also provides access to one RS-232 channel (AUDIX
networking channel 5), and RS-232 connector B provides access to another RS-232 channel (AUDIX
networking channel 6).