Clear-Com Production-Maestro-Pro - Manual (Page 45)

Clear-Com
Eclipse Production Maestro V5.2 User Manual 1 - 3 5
Figure 1-42: Adding Audio Meters to a 4-Wire on the Palette
To remove a meter from a 4-Wire port on the palette the user must be
in ‘Configure Palette’ mode. Use the mouse to drag the audio meter
away from the 4-Wire port and drop it on the palette.
To Add a Meter to a 4-Wire on the Canvas
A new type of 'Fixed 4-Wires' has been introduced in release V5.2.
Unlike the 4-Wire viewer it is not possible to change the 4-Wire
attached to the Fixed 4-Wire viewer once it has been added to the
canvas.
Note: It is not possible to add meters to the 4-Wire viewer
introduced in previous versions of Production Maestro.
Fixed 4-Wire viewers are displayed in ‘Configure Canvas’ mode under
the ‘4-Wires’ tab. All the 4-Wire ports present in the system
configuration will be shown under the ‘4-Wires’ tab except 4-Wire ports
configured as monitors or idents.