Clear-Com Production-Maestro-Pro - Manual (Page 41)

Clear-Com
Eclipse Production Maestro V5.2 User Manual 1 - 3 1
Additional ports can be connected to the port being monitored by
dragging and dropping the required port into the 4-Wire Viewer. These
ports appear in the 4-Wire Viewer list and a new talk and listen
crosspoint will be made between the new port and the monitored port.
The matrices will be updated by Production Maestro with the new
configuration.
The effects of dragging and dropping a new port into a 4-Wire Viewer
list differs depending on whether the left or right mouse button is used
to select the port. The left mouse button always performs the default
operation while the right mouse button performs the non-default
operation.
• If the left mouse button is used to select and drag a port from the
palette to the destination 4-Wire Viewer it will be added to that
viewer without affecting any other 4-Wire Viewer.
• If the right mouse button is used to select and drag a port from the
palette to the destination 4-Wire Viewer it will be exclusive to the
destination viewer and will be removed from any other viewer it
may be listed in.
The talk and listen properties of the new port can be changed by
clicking on the talk or listen buttons as with ports in conferences.
Ports that have been added to the monitored port in the 4-Wire Viewer
can also be disconnected from the monitored ports by dragging the
port out of the viewer and dropping it on an empty area of canvas or
back in the palette.
More than one instance of the 4-Wire Viewer can be placed on the
canvas so it is possible to use this to monitor a number of different
ports simultaneously.
An alias can assigned to a 4-Wire by dragging and dropping an Alias
from the Alias palette onto the viewer in the same way as
conferences.
If the Production Maestro configuration is saved to a ccr file with
4-Wire viewers present they will also be saved with any ports being
monitored and restored when the ccr file is opened.
Notes
The Notes template (Pro mode only) is available under the ‘Other’ tab
in ‘Configure Canvas’ mode and allows operator notes to be added to
the canvas. To enter a note select the template and type in the
required text and then drag the note onto the canvas. The note will
remain fixed on the canvas in ‘Assignment’ mode in the same way as
conferences and 4-Wire viewers.
To remove a note from the canvas simply drag and drop the note onto
the palette in ‘Configure Canvas’ mode.
Pro Mode only