Clear-Com Production-Maestro-Pro - Manual (Page 44)

Clear-Com
Eclipse Production Maestro V5.2 User Manual
1 - 3 4
When performing cross-system metering in a fiber-linked system (i.e.
the point being metered and the EMC card are in different matrices)
fiber channels will be used. Therefore it is advisable to place the EMC
card in the matrix where most metering is likely to take place.
Note: It is not possible to perform output level metering of ports
that are not on the same system as the EMC card.
• Input meters display the audio level into the matrix from a port, after
input level adjustment has been applied.
• Output meters display the audio output level from the matrix to a port
after output level adjustment has been applied.
• Conference meters display the mixed audio level. If their own output
level is set to 0db conference members will hear it.
• The meter setups are saved as part of the Production Maestro
configuration in the ccr file.
• Audio level meters can be added to 4-Wire ports in the palette in a
reduced format.
To Add a Meter to a 4-Wire on the Palette
Select Configure Palette mode. An audio meter control will be
displayed on the toolbar at the top of the canvas area next to the
eraser.
Figure 1-41: Toolbar Showing Audio Meter Control
Add the required 4-Wire port to the palette if it is not already present.
To add an input meter drag the meter control to the left-hand-side of
the 4-Wire in the palette. The meter display will appear at the top of the
4-Wire.
To add an output meter drag the meter control to the right-hand-side of
the 4-Wire in the palette. The meter will appear at the bottom of the
4-Wire.