ELRO HIS20S Security & home automation system EXPANDED USERS MANUAL - Manual (Page 52)

50
Use (On), (Off), (Start) and (Stop)
buttons to control the green control related actions.
Scene
Press to enter scene selection function, and
use and buttons to select desired scene to
be execute, and then press .
All On/All Off
Press to turn ON all the green control device,
or
Press to turn OFF all the green control device.
Note: Our curtain switch devices cannot be executed
All On/All Off function.
Event Log
The Event Log will store the last 100 system arm,
disarm, alarm and detector Low Battery events. The
Event Log will record the time, date and details for
each event. If when the system is disarmed the
‘ALARM MEM/MESSAGE’ LED is flashing and the
Smart Home Box beeps every 10s which is changeable
(refer to ‘home box’ setup under sub-menu ‘error beep’
for selection), this indicates that an alarm has occurred.
To cancel the LED and stop the beeping you must
access the event log and press to exit so as
to eliminate the flashing ‘ALARM MEM/message’ LED
and the beeping as well.
To access the Event Log, press .
The Event-Log will automatically start scrolling through
and displaying the event data starting with the most
recent event. The data for each event is shown on
two screens (event name first follow by event day) ,
and each screen will be displayed for 5 seconds before
moving on to the next screen and then the next event.
Use the and buttons to manually scroll
through the event log to the required position as
necessary.
Press to return to Disarm.
LED INDICATION
The LED indication represents the following status:
On steadily Flash Off
AC power in use Battery in use
-----
System is
Fully/holiday
armed
System is set in
Partial/Night arm
System is
disarmed
Message Alarm memory Normal
Telephone in use Abnormal
telephone line
Normal
telephone line
FUNCTION KEY
There are four Function Keys on the front panel of the
Smart Home Box.
The package includes PIR Detector, Magnet Contact
Detector, Green Control and Green Remote Sensor.
Once function key is pressed, the devices will enter
arm/disarm (security/home automation) mode. The
table below lists the preset setting of these four devices
after function key is pressed.
Device
Function
Key
Preset
Message
PIR
Detector
Magnet
Contact
Detector
Green
Control
(Fully Arm)
I will
watch
over the
house!
Security Security OFF
(Disarm)
Welcome
home
Home
Automation
Home
Automation
ON
(Night Arm)
Good
night,
sweet
dream
Home
Automation
Security Unchange
Three Function keys
Panic Key
Microphone