ELRO HIS20S Security & home automation system EXPANDED USERS MANUAL - Manual (Page 42)

40
Enter the required number (1-6).
Press to save and exit, or
Press to exit without saving.
DIAL ROUND
This sets the maximum number of times that the dialer
will attempt to contact each enabled telephone number
in the call routing sequence.
Default setting: 3
Scroll through the menu until ‘5-3 Dial Round’ is
displayed. The current setting will also be displayed.
To change the setting press .
Enter the required number (1-9).
Press to save and exit, or
Press to exit without saving.
ALARM MESSAGE PLAY TIME
This is the total time for which the alarm messages will
be played & repeated when a call made by the voice
dialer is answered.
Default setting: 70s
Scroll through the menu until ‘5-4 Play Time’ is
displayed. The current setting will also be displayed.
To change the setting press .
Scroll through the available options, (50, 70, 90 and
110s) until the required setting is displayed.
Press to save and exit, or
Press to exit without saving.
CALL ABORT
This feature, if enabled, will delay the activation of the
telephone dialer following an alarm for a period of
approx. 33s to allow the system to be disarmed.
Default setting: OFF
Scroll through the menu until ‘5-5 Call Abort’ is
displayed. The current setting will also be displayed.
To change the setting press .
Press to enable Call Abort, or
Press to disable Call Abort.
Note: If you find Voice Dial is not working properly,
please check the telephone no. you enter is correct,
Level Panic, Level 1 are set to ON and the message
you recorded in Main Message is working.
Enter Remote
TEL Control
Dial next
call
Event Trigger
YES
NO
KEY = ‘ º ’
Cancel
this call
KEY = ‘0’~’9’
Hang up
the phone
KEY=’＃’
KEY
NO
End
Playtime
timeout
Dial Preset
TEL No.
Play trigger
message
YES
NO