ELRO HIS20S Security & home automation system EXPANDED USERS MANUAL - Manual (Page 23)

21
PROGRAMMING INSTRUCTIONS
With the system in Disarm Mode.
Press , ,
Admin Password
The system is now in the Programming Mode
Use the and buttons to scroll through
the programming menu. Press to select the
displayed programming function or sub-menu.
Note: Programming is only available under Disarm
Mode. While you are using the PC to do the program
setting, the keypad on the Smart Home Box will
become inactive unless you press for 3 seconds.
After programming all required functions press
to leave Programming mode and return to Disarm
mode.
USER SETUP
Scroll through the top level programming menu until ‘1.
USER SETUP’ is displayed and press .
Use the and buttons to scroll through
the menu until the required user to be configured is
displayed and press .
Note: After configuring all required users press
to return to the top level programming menu.
ADMIN. & USERS 1-7
Default setting: not programmed
Scroll through the menu until the required User to be
configured is displayed and press .
ADMIN. & USER PASSWORD
Scroll through the menu until ‘:1 Password’ is
displayed. For security purpose, the Admin.
password won’t be displayed, only User password will
be shown on the display.
To change the setting press .
Enter the new 4 digit Password and then
Press to save and exit, or
Press to exit without saving.
USER NAME
This enables each user’s name to be shown on the
:7-1 Learning ID
:1 Password
xxxx
Enter Password:
CODE:
:2 Name
xxx
Enter Name:
:3 TEL/SMS
Remote: xxx
:4 Latchkey
Report: xxx
Select
Start->＊ Stop->＃
:5 Record
User Message
PROGRAM MODE
Code:
1. User Setup
1-1 Admin SETUP
1-2 USER1 1-3 USER2 1-4 USER3 1-5 USER4 1-6 USER5 1-7 USER6 1-8 USER7
Select
ON->＊ OFF->＃
Select
ON->＊ OFF->＃
Recording
Stop->ESC
Playing
Stop->ESC
Select
ON->＊ OFF->＃
Select
YES->＊ NO->＃
:6 Replay
User Message
Playing
Stop->ESC
:7 Remoter
:7-2 Panic :7-3 Status :7-4 Del Data
Wait Learning Select
ON->＊ OFF->＃