ELRO HIS20S Security & home automation system EXPANDED USERS MANUAL - Manual (Page 25)

Code Learning
Pressing , or button on the remote
control will enable the Smart Home Box to learn the ID
code.
Scroll through the menu until ‘:7-1 Learning ID’ is
displayed.
Three results would turn up after learning as follows:
Learning OK
– the ID code was learned by the Smart
Home Box successfully.
Time Out
– the time involved for learning the ID code is
60s. During this duration, fail to press the button
on the remote control would result in overdue
programming.
ID Duplicate
– the same ID code was learned by the
Smart Home Box beforehand.
Panic Switch
This feature, if enabled, allows the Smart Home Box to
alarm when the panic switch on the remote control is
pressed in case of an emergency.
Default setting: ON
Scroll through the menu until ‘:7-2 Panic’ is displayed.
To change the setting press .
Press to enable the function of Panic Switch,
or
Press to disable the function of Panic Switch.
Status
This enables the remote control to control the Smart
Home Box in the event that the remote control was lost
unexpectedly.
Default setting: ON
Scroll through the menu until ‘:7-3 Status’ is displayed.
To change the setting press .
Press to enable the function of remote control
or
Press to disable the function of remote control.
Delete Remote Control
In case of unexpected factors, this facility allows you to
delete the remote control setting from the Smart Home
Scroll through the menu until ‘:7-4 Del data’ is
displayed.
To change the setting press .
Press to delete the remote control setting, or
Press to keep the same setting.
Press to return to the top level User-Setup
menu.
Note : After the system enters the programming mode,
if no further programming setting is taken within 10
minutes, the system will return to disarm mode
automatically.
Note : By means of either using PC or Smart Home
Box’s keypad to enter the programming mode, the
system will enter disarm mode first then programming
mode in sequence.
Box.
23