ELRO HIS20S Security & home automation system EXPANDED USERS MANUAL - Manual (Page 22)

20
Backup & Restore
Backup Today’s DD/MM/YY
Restore Not Programmed
RESET
After carrying out the following steps, the Smart Home
Box will not return to factory default, instead, the
memory of any settings and learnt devices (e.g. PIR
detector, magnetic contact detector and remote control)
will all be washed out. To reset the Smart Home Box:
1. Press
, ,
User Password
to place the system in Test Mode.
2. Undo the Smart Home Box cover fixing screws and
open the cover.
3. Switch OFF the mains supply to the plug-in PSU
Adaptor and remove the plug from the DC power
socket in the Smart Home Box.
4. Remove either back-up battery and disconnect the
battery leads.
5. Set jumper link P1 to the ON position.
6. Reconnect the battery leads and replace the
back-up battery in position.
Reconnect the PSU Adaptor plug to the DC power
socket in the Smart Home Box and switch On the
supply to the PSU Adaptor.
7. As the Smart Home Box powers-up, ‘EEPROM
Reset’ will be displayed indicating reset is taking
progress. Once the memory reset has been
completed, ‘DISARM READY’ will be displayed.
The Smart Home Box will now be reconfigured with
new settings.
8. Reset jumper link P1 to the OFF position.
9. Close the Smart Home Box cover and refit the
fixing screws.
Note: please always remember the next step you
should carry out after resetting the Smart Home Box is
ID code learning for each device.