ELRO HIS20S Security & home automation system EXPANDED USERS MANUAL - Manual (Page 50)

48
OPERATING INSTRUCTIONS
When leaving the premises, the system must be Armed.
However, before doing so, check that all windows are
closed and locked, all protected doors are closed and
Motion Detectors are not obstructed. Ensure that pets
are restricted to areas not protected by Motion
Detectors.
The system has four arming modes, Fully Arm, Holiday
Arm, Partial Arm and Night Arm. The Night Arm is
similar to Partial Arm which allows selected zones to be
left in Disarm while the remaining system stays in Arm,
whereas Holiday Arm is similar to Fully Arm.
When the system is Armed (in any mode) the Smart
Home Box will display the arming mode and the status
of the Latch Key for a few seconds. If enabled, the
system Exit-Delay will start and be counted down on
the display. As the Exit-Delay expires the Smart
Home Box will beep, with the beep rate increasing in
steps as the delay expires. At the end of the
Exit-Delay all active zones will be Armed. By this time
the user should already be out of the property with the
door closed.
If while the system is armed a detector on an active
zone is triggered, if enabled, the programmed
Entry-delay for all zones will start and be counted down
on the display. As the Entry-Delay expires the Smart
Home Box will beep, with the beep rate increasing in
steps as the delay expires. If the system has not been
disarmed when the Entry-Delay expires an alarm will
occur. If however, the Entry-Delay for the triggered
zone has been disabled an alarm will occur
immediately.
At the end of the programmed alarm duration the Siren
and Smart Home Box alarms will stop and the system
will automatically re-Arm.
FULLY ARM
To set the Smart Home Box in Fully Arm, using either
the Remote Control or the Smart Home Box as follows:
Remote Control:
Press the ‘Arm’ button, .
Smart Home Box:
Press the ‘Arm’ button followed by the User Password
and then the ‘Enter’ button:
,
User Password
By pressing , the programmed exit delay will be
overridden to 5 seconds.
Note: Once the system is armed, the ‘ARM’ LED stays
on steadily.
HOLIDAY ARM
Remote Control:
Press the ‘Arm’ button, , enabling the Smart Home
Box to enter Fully Arm. Press the ‘Arm’ button
again to enter Holiday Arm.
Smart Home Box:
Toggle the ‘Arm’ button between ‘Fully Arm’ and
‘Holiday Arm’. When ‘Holiday Arm’ appears, input
User Password and then the ‘Enter’ button. If the
User Password is correct, an indication of ‘Holiday Arm’
will be shown on the LCD screen.
,
User Password
By pressing , the programmed exit delay will be
overridden to 5 seconds.
Note: Once the system is armed, the ‘ARM’ LED stays
on steadily.
NIGHT ARM
To set the Smart Home Box in Night Arm, using either
the Remote Control or the Smart Home Box as follows:
Remote Control:
Press the ‘Night Arm’ button, , .
Smart Home Box:
Press the ‘Night Arm’ button followed by the User