ELRO HIS20S Security & home automation system EXPANDED USERS MANUAL User Manual
Page 37
35
Press to delete the character under the cursor.
Press and hold to erase the entire phone
number.
UNIT ID NUMBER
This helps central monitoring station set an ID number
for the user whose system is connected to their center.
Scroll through the menu until ‘:3 Unit ID No:’ is
displayed. The current setting will also be displayed.
To change the setting press .
Enter the ID number (4 digits max. ranging from 0-9,
B,C,D,E, F)
Press to save and exit, or
Press to exit without saving.
Notes:
Press and then 1, a ‘B’ will be presented.
Press and then 2, a ‘C’ will be presented.
Press and then 3, a ‘D’ will be presented.
Press and then 4, an ‘E’ will be presented.
Press and then 5, a ‘F’ will be presented.
When pressing for 3 seconds, it will return to
numbers.
CALL ATTEMPTS
This sets the maximum number of times that the dialer
will attempt to contact the central monitoring station.
If the dialer contacts to the central monitoring station
once successfully, it will stop dialing.
Default setting: 3
Scroll through the menu until ‘:4 Call Attempts’ is
displayed. The current setting will also be displayed.
To change the setting press .
Enter the required number (1-5).
Press to save and exit, or
Press to exit without saving.
ARM/DISARM BY USER
This determines when user makes a selection for
disarming (Open) or arming (Close) the system, an
event code 401 is needed to be sent to the central
monitoring station. When setting to ‘On’, an event
code 401 will be emitted, setting to ‘Off’, an event code
401 won’t be emitted.
Default setting: OFF
Scroll through the menu until ‘:5 ARM/DISARM By
User’
is displayed. The current setting will also be
displayed.
To change the setting press .
Press to commence sending the event code.
Press , event code will not be sent.
CYCLIC TEST
This function allows you to set the time interval for the
dialer to report to the central monitoring station.
Default setting: Disable
Scroll through the menu until ‘:6 Cyclic Test’ is
displayed. The current setting will also be displayed.
To change the setting press .
Scroll through available options, (Disable, 6 Hours,
12 Hours and 24 Hours), until the required setting is
displayed.
Press to save and exit, or
Press to exit without saving.