ELRO HIS20S Security & home automation system EXPANDED USERS MANUAL - Manual (Page 33)

31
- used to provide 24-hour monitoring of any
Fire/Smoke detectors fitted to the system.
Activation of any detector will immediately initiate a
Full Alarm condition.
Panic/PA
- used to provide 24-hour monitoring of any
emergency being occurred. Activation of any
Panic and Flood Status will immediately initiate a
Full Alarm condition.
Note: Panic/PA, 24-hour Intruder and Fire modes all
operate on a 24 hour basis, (i.e. they are able to initiate
Full Alarm condition at any time irrespective of whether
the system is Armed or Disarmed).
Default setting: ‘Intruder’
Scroll through the menu until ‘:4 Security Type’ is
displayed. The current setting will also be displayed.
To change the setting press .
Scroll through available options until the required
setting is displayed.
Press to save and exit, or
Press to exit without saving.
CHIME
This controls whether the Chime facility is available on
the zone.
For example, if a Magnet Contact Detector
is set as disable in Partial Arm while the Chime facility
is set to ON, then once the Magnet Contact Detector
has been triggered, the Smart Home Box will send out
a Ding-Dong sound.
Default setting: OFF
Scroll through the menu until ‘:5 Chime Mode’ is
displayed. The current setting will also be displayed.
To change the setting press .
Press to enable the sensor zone’s Chime
facility, or
Press to disable the sensor zone’s Chime
facility.
NIGHT ARM
This facility controls whether the sensor zone is active
when the system is set to night arm.
Default setting: OFF
Scroll through the menu until ‘:6 Night Arm’ is
displayed. The current setting will also be displayed.
To change the setting press .
Press to enable sensor zone’s night arm
facility, or
Press to disable sensor zone’s night arm
facility.
Press to save and exit, or
Press to exit without saving.
PARTIAL ARM
This facility controls whether the sensor zone is active
when the system is set to Partial Arm.
Default setting: OFF
Scroll through the menu until ‘7: Partial Arm’ is
displayed. The current setting will also be displayed.
To change the setting press .
Press to enable the sensor zone in Partial
Arm, or
Press to disable the sensor zone in Partial
Arm.
MAGNETIC CONTACT DETECTOR
This allows the Smart Home Box to be notified as to
whether the magnetic contact detector is active or
inactive when the system is disarmed.
Default setting: ON
Scroll through the menu until ‘:8 Magnetic O/C Det.’ is
displayed. The current setting will also be displayed.
To change the setting press .
Press to enable the Magnetic Contact
Detector, or