ELRO HIS20S Security & home automation system EXPANDED USERS MANUAL - Manual (Page 30)

28
Press to enable the Entry-delay beep, or
Press to disable the Entry-delay beep.
DATE
This feature is for setting of local date.
Default setting: 1/1/2011 Sat
Scroll through the menu until ‘2-15 Date’ is displayed
and press .
Enter the date in the format ‘DD/MM/YY’.
Press to save and exit, or
Press to exit without saving.
TIME
This feature is for local time setting.
Default setting: 12:00:00
Scroll through the menu until ‘2-16 Time’ is displayed
and press .
Enter the time in the format ’hh/mm/ss’.
Press to save and exit, or
Press to exit without saving.
WIRELESS KEYPAD
This feature, if enabled, allows the Smart Home Box to
be controlled up to 6 pcs of wireless keypad with ease.
Default setting: OFF
Scroll through the menu until ‘2-17 Wirefree Keypad’
is displayed. The current setting will also be displayed
and press .
Scroll through the menu until ‘:1 Wirefree Keypad 1:
xxx’
is displayed and press to enter code
learning.
Code Learning
Scroll through the menu until ‘:1 Learning ID’ is
displayed.
Three possibilities would happen as follows:
Learning OK
– the ID code was learned by the Smart
Home Box successfully.
Time Out
– the time involved for learning the ID code is
60s. During this duration, fail to press the button
on the remote control would result in overdue
programming.
ID Duplicate
– the same ID code was learned by the
Smart Home Box beforehand.
Keypad Off
Scroll through the menu until ‘:2 Keypad Work: xxx’ is
displayed and press .
Press to enable the Wireless Keypad, or
Press to disable the Wireless Keypad.
Delete Keypad
Up to 6 pcs of wireless keypad can be controlled by the
Smart Home Box.
Scroll through the menu until ‘:3 Del Keypad’ is
displayed and press .
Press to delete the Wireless Keypad, or
Press to keep the Wireless Keypad.
The same method is applied for learning other keypads,
for example scroll through the menu until ‘:2 Wirefree
Keypad 2: xxx’
is displayed and press to enter
code learning.
EVENT & SCHEDULE
To enable/disable the preset schedules and event
under Fully Arm and Partial Arm, scroll through the
menu until ‘2-18 Event & Schedule’ is displayed.
Default setting: ON
To change the setting press .
Press to enable all schedules & events or
Press to disable all schedules & events.
Note: The schedules and events set under holiday arm
and Night arm will not be affected by this function
setting; they still execute even event & schedule is set
to off.