ELRO HIS20S Security & home automation system EXPANDED USERS MANUAL - Manual (Page 28)

26
KEY TONE
This feature, if enabled, allows the Smart Home Box to
sound a tone each time the keypad is pressed.
Default setting: ON
Scroll through the menu until ‘2-4 Key Tone’ is
displayed. The current setting will also be displayed.
To change the setting press .
Press to enable Key Tone, or
Press to disable Key Tone.
The setting will become effective after it returns back to
the top level programming menu.
SMART HOME BOX BACK LIGHT
This controls the time period that the backlight for the
Smart Home Box display will stay illuminated for after
the last key is pressed.
Default setting: 20s
Scroll through the menu until ‘2-5 Back Light’ is
displayed. The current setting will also be displayed.
To change the setting press .
Scroll through available options, (5, 10, 20, 30 and
60s) until the required setting is displayed.
Press to save and exit, or
Press to exit without saving.
WARNING BEEP
When any abnormal conditions have occurred such as
the system being triggered or detectors’ low battery, the
‘ALARM MEM/MESSAGE’ LED on the Smart Home
Box will be on accompanying warning beep as a
reminder. This feature, if enabled, allows the Smart
Home Box to be emitted a warning beep periodically
once abnormal conditions is occurred.
Note:
to avoid warning beep being disturbed from
10:00 pm to 6:00 am, the Smart Home Box will not emit
warning beep during this period of time.
If ‘ALARM MEM/MESSAGE’ LED is flashing while the
system is disarmed and the Smart Home Box beeps
periodically, this indicates an alarm has occurred. To
cancel the LED and stop the beeping you must access
the event log, so as to eliminate the flashing ‘ALARM
MEM/MESSAGE’ LED and the beeping as well.
Default setting: 30S
Scroll through the menu until ‘2-6 Error Beep’ is
displayed. The current setting will also be displayed.
To change the setting press .
Scroll through available options, (10SEC, 30SEC,
1MIN, 2MIN, 4MIN and OFF)
until the required
setting is displayed and then
Press to save and exit, or
Press to exit without saving.
AUTO REPORT
The associated detectors will emit a radio signal to the
Smart Home Box once an hour as an
acknowledgement of proper operation. If within a
certain period of time, the Smart Home Box does not
receive a radio signal from the detectors, this feature (if
it’s enabled) allows the Smart Home Box to show an
abnormal indication as a reminder.
Default setting: 12H
Scroll through the menu until ‘2-7 Auto Report Func.’
is displayed. The current setting will also be displayed.
To change the setting press .
Scroll through available options, (3, 6, 12, 24, 48,
72 HOUR & OFF)
until the required setting is
displayed and then
Press to save and exit, or
Press to exit without saving.
JAMMING DETECTION
This feature controls the Smart Home Box RF jamming
detection circuitry, which if enabled, will continuously
scan for radio jamming signals on the system operating
frequency.
Default setting: OFF
Scroll through the menu until ‘2-8 RF Jamming
Detection’
is displayed. The current setting will also
be displayed.
To change the setting press .
Press to enable Jamming Detection, or
Press to disable Jamming Detection.