ELRO HIS20S Security & home automation system EXPANDED USERS MANUAL - Manual (Page 39)

37
NUMBER OF DIALING CALL
This facility controls the number of dialing call via the
connected telephone line.
Default setting: one call
Scroll through the manual until ‘:1 Remote Type’ is
displayed and press .
To change the setting press .
Scroll through available options (e.g. one call & double
call) until the required setting is displayed.
One Call
The number of ring for the Smart Home Box must be
greater than that of the set number of rings. By doing
so, the Smart Home Box will answer the call and emit
three beeps on the phone line to prompt for a User
Password to be entered using the telephone keypad.
Refer to the section ‘‘NUMBER OF RINGS FOR ONE
CALL’ below for the setting.
Double Call
This feature is suitable for use when the fax or answer
machine is connected to Smart Home Box externally.
The operating procedure is as follows:
1. Dial up the system and hang up after two rings.
2. Redial up the system within 25s as maximum (10s
as minimum), the system will pickup the phone and
emit 3 beeps to remind the user to enter
passwords for long term controlling.
Note: The maximum and minimum period for
redialing up the system will vary depending on the
interval of ring you entered. Refer to ‘INTERVAL
OF RING FOR DOUBLE CALL’ for the setting.
3. Enter the User Password as normal.
NUMBER OF RINGS FOR ONE CALL
The number of rings for one call must be set within 2-9.
Default setting: 6
Scroll through the menu until ‘:2 One Call Ring’ is
displayed and press .
Enter the required number of ring (2-9).
Press to save and exit, or
Press to exit without saving.
INTERVAL OF RING FOR DOUBLE CALL
The interval of ring in each country varies greatly.
Always add extra 2s to your countries’ interval of ring.
Default setting: 13s
Scroll through the menu until ‘:3 Double Call Time’ is
displayed. The current setting will also be displayed.
To change the setting press .
Enter the required interval of ring (5s-15s).
Note: The duration of dialing the second call will vary
depending on the interval of ring you enter.
Enter 5s, it becomes 6-20s.
Enter 13s, it becomes 14-28s.
Enter 15s, it becomes 16-30s.
DIAL METHOD
This feature enables the telephone dialer to be
configured for type of exchange it is connected to.
Default setting: DTMF (Tone)
Scroll through the menu until ‘4-4 Dial Method Setup’
is displayed. The current setting will also be
displayed.
To change the setting press .
Scroll through available options, (DTMF/PULSE), until
the required setting is displayed and then
Press to save and exit, or
Press to exit without saving.