ELRO HIS20S Security & home automation system EXPANDED USERS MANUAL - Manual (Page 51)

49
Password, and then the ‘Enter’ button. If User
password is correct, an indication of ‘Night Arm’ will be
shown on the LCD screen:
,
User Password
By pressing , the programmed exit delay will be
overridden to 5 seconds.
Note: Once the system is in Night Arm, the ‘ARM’ LED
is flashing on and off alternatively.
PARTIAL ARM
Remote Control:
Press the ‘Night Arm’ button, , enabling the Smart
Home Box to enter ‘Night Arm’. Press the ‘Night Arm’
button again to enter ‘Partial Arm’.
Smart Home Box:
Toggle the ‘Night Arm’ button between ‘Night Arm’ and
‘Part-Arm’. When ‘Part-Arm’ appears, input the User
Password and then the ‘Enter’ button. If the User
Password is correct, an indication of ‘Part-Arm’ will be
shown on the LCD screen.
,
User Password
By pressing , the programmed exit delay will be
overridden to 5 seconds.
Note: Once the system is in Partial Arm, the ‘ARM’
LED is flashing on and off alternatively.
DISARM
To disarm the Smart Home Box, using either the
Remote Control or the Smart Home Box as follows:
Remote Control:
Press the ‘DISARM’ button, .
Smart Home Box:
,
User Password
If the system is disarmed and the ‘ALARM
MEM/MESSAGE’ LED is flashing with the panel
beeping every few seconds, this indicates that an
alarm condition has occurred. Use the Event Log to
find out and make a note of where the alarm occurred
to assist in tracing the cause of the alarm.
QUICK SET
The following lists a series of quick set functions by
using digit buttons. Please make sure the Smart
Home Box is in DISARM mode before you operate
them.
Countdown Shortening
To shorten the countdown time in 5s, overriding the
programmed exit delay.
Press
User Password
This allows the system enters Fully Arm Mode.
Chime
Press to toggle the Chime facility between ON
and OFF.
Note: If the Chime is ON and the system is then armed,
the Chime will remain ON even though the system is
disarmed later.
Mute
Press to toggle the Mute facility between ON
and OFF.
Note: If the Mute is ON, no voice guidance will be
made during operation. If the mute is OFF, voice
guidance will be active. However, if ‘LINE STATUS’
LED illuminates while the mute is ON, there is no voice
guidance will be available.
GREEN CONTROL FUNCTION
Press to enter green control selection function,
and use the and buttons to select desired
green control to be executed, and then press .