ELRO HIS20S Security & home automation system EXPANDED USERS MANUAL User Manual

Page 48

Enhance setting is designed specially for transceiver
type of devices, i.e. device with 868 MHz radio
frequency.

Scroll through the top level programming menu until ‘7.

Enhance Device’

is displayed and press .

Enter device number (1-12) to be configured and
press .

Model Type
After inputting Device Number, ‘:1 Model Type’ is
displayed. The model name of the learned device will
be displayed.

Code Learning
This enables the Smart Home Box learns ID from each
transceiver.

Scroll through the menu until ‘:2 Learning ID’ is
displayed and press .

Press learning key on the device will emit ID code to
the Smart Home Box instantly.

Three possibilities would happen as follows:

Learning OK

– the ID code was learned by the Smart

Home Box successfully.

Time Out

– the time for ID code learning is 30s.

During this time, if the Smart Home Box failed to
capture the ID code emitted by device, it would result in
overdue programming.

ID Duplicate

– the same ID code was learned by the

Smart Home Box beforehand.

Device Status

This sets the device to be enabled or disabled. Scroll
through the menu until ‘:3 Device Status’ is displayed.

Default setting: OFF

To change the setting press .

Press to enable the device, or
Press to disable the device.

Note:

ON implies enable whereas OFF implies disable.

The default setting will change to ON automatically
once code learning is completed.

Device Deletion
To delete the device, scroll through the menu until ‘:4

Device Reset’

is displayed.

To change the setting press .

Press to delete the device, or
Press to cancel deletion.

GSM Gateway SMS Remote
To enable/disable GSM Gateway to control Smart
Home Box remotely, scroll through the menu until ‘7-3

GSM Gateway SMS Remote’

is displayed.

Default setting: ON

To change the setting press .

Press to enable remote control, or
Press to disable remote control

If Smart Home Box is controlled by GSM Gateway

using SMS message turns out to be not safe

enough, the user may disable this feature.