ELRO HIS20S Security & home automation system EXPANDED USERS MANUAL - Manual (Page 29)

27
ALARM RELAY
This setting controls the operation period for the
NO/NC hardwired output relay contacts following an
alarm condition being initiated.
If this is set to ‘ON Until Disarm’ then the relay will
latch and remain On until the system is next disarmed.
Scroll through the menu until ‘2-9 Alarm Relay’ is
displayed. The current setting will also be displayed.
Default setting: ON Until Disarm
To change the setting press .
Scroll through available options, (Pulse 2Sec,
30Sec, 1Min, 3Min, 5Min and On Until Disarm )
until the required setting is displayed and then
Press to save and exit, or
Press to exit without saving.
ZONE LOCKOUT
This feature, if enabled, prevents a single zone from
triggering an alarm condition more than three times
before the system is disarmed. However, if disabled,
there is no limit on the number of times a zone can
trigger an alarm condition.
Default setting: ON
Scroll through the menu until ‘2-10 Zone Lock’ is
displayed. The current setting will also be displayed.
To change the setting press .
Press to enable Zone Lockout, or
Press to disable Zone Lockout.
EXIT DELAY
It controls how long the exit delay expires.
Default setting: 30s
Scroll through the menu until ‘2-11 Exit Delay’ is
displayed. The current setting will also be displayed.
To change the setting press .
Scroll through available options, (10SEC, 30SEC,
1MIN, 2MIN, 4MIN and OFF) until the required
setting is displayed and then
Press to save and exit, or
Press to exit without saving.
EXIT DELAY BEEP
This controls the warning beep which operates during
the Exit Delay period when Arm is initiated.
Default setting: ON
Scroll through the menu until ‘2-12 Exit Delay Beep’ is
displayed. The current setting will also be displayed.
To change the setting press .
Press to enable the Exit-delay beep, or
Press to disable the Exit-delay beep.
ENTRY DELAY
This facility controls the delay time which allows the
user to enter the property without initiate an alarm. If
it’s set to OFF, the system will alarm immediately once
a detector is triggered.
Default setting: OFF
Scroll through the menu until ‘2-13 Entry Delay’ is
displayed. The current setting will also be displayed.
To change the setting press .
Scroll through available options, (10SEC, 30SEC,
1MIN, 2MIN, 4MIN and OFF) until the required
setting is displayed and then
Press to save and exit, or
Press to exit without saving.
ENTRY DELAY BEEP
This controls the warning beep which operates during
the Entry Delay period when Arm is active.
Default setting: OFF
Scroll through the menu until ‘2-14 Entry Delay Beep’
is displayed. The current setting will also be displayed.
To change the setting press .