B&K Precision 2532B - Manual - Manual (Page 174)

174
“Save/Recall” menu , Press the “Save” option button or the
“time/div” knob before inverting the USB Flash Drive to the USB
Host port or this will appear on the screen.
• Record Wave Success! : This message will appear when you
finish recording waveforms.
Troubleshooting
1. After the oscilloscope is powered on, the screen remains dark.
Please do the following:
1. Check the power cable’s connection.
2. Ensure the power switch is turned on.
3. After the inspections above, restart the oscilloscope.
4. If the oscilloscope is still not useable after checking,
please connect B&K Precision.
2. If there is no signal wave in the screen after probing DUT for a
signal, please do as follows:
1. Check whether the probe is connecting with the signal
cable or not.
2. Check whether the signal cable is connected with the
BNC connector or not.