B&K Precision 2532B - Manual - Manual (Page 143)

143
5. Press the “SINGLE” button to start updating the software
according to prompt on the screen.
When completed, turn off the oscilloscope and turn on again. The software
will then be updated. The oscilloscope needs to execute “Do Self Cal” after
update.
Note: Don’t turn off the power while oscilloscope is updating.
Otherwise, firmware will be corrupted and unit may not be able to
boot up.
Pass/Fail
The Pass/Fail function can monitor changes of signals and output pass or
fail signals by monitoring the input signal and checking if its within the
predefined mask or not.
Table 55 - Pass/Fail Function Menu 1
Option Setting Instruction
Enable On
Off Turn on Pass/Fail function.
Turn off Pass/Fail function.
Source CH1
CH2 Select signal input channel.
Operate Press to run the Pass/Fail test.
Press to stop the Pass/Fail test.
Msg Display
On
Off Turn on times information display
of the waveform pass/fail.
Turn off times information display