B&K Precision 2532B - Manual - Manual (Page 165)

165
1. Set the Probe option attenuation to 10X and set the switch to 10X
on the probe.
2. Trigger set up:
1) Press “TRIG MENU” button to show the “Trigger Menu”
2) Under this menu, set the trigger type to “edge”, Edge type
is “Rising”, source is “CH1”, trigger mode is “Single”,
coupling is “DC”
3) Adjust the horizontal time base and vertical scale to the
satisfied range
4) Turn the “LEVEL” knob to adjust the trigger level
5) Press the “RUN/STOP” button to start capturing
When the trigger conditions are satisfied, data appears on the display
representing; the data points that the oscilloscope obtained with one
acquisition and press the RUN/STOP button again rearms the trigger circuit
and erases the display.