B&K Precision 2532B - Manual - Manual (Page 119)

119
Save/Recall Setup
• Save Setups to Device: The complete setup is stored in
nonvolatile memory. When you recall the setup, the oscilloscope
will be in the mode from which the setup was saved.
The oscilloscope saves the current setup if you wait three seconds
after the last change before you power off the oscilloscope. The
oscilloscope recalls this setup the next time you apply power.
Table 41 - Save Setup to Device Function Menu
Option Setting Introduction
Type Setups Menu for the Storage/Recall setting
in the oscilloscope
Save to Device Save setup to the oscilloscope’s
internal memorizer.
Setup No.1 to No.20 Press the “Setup” option button or
turn the “universal” knob to select
storage position.
Save Accomplish the storage
Recall Recall the storage in the “Setup”
operation
Figure 60 - Save/Rec Menu