B&K Precision 2532B - Manual - Manual (Page 142)

142
Figure 74 - LED Test Screen
Updating the System Software
• Using USB flash drive to update firmware
The software of the oscilloscope can be updated directly via USB Flash
drive. This process takes about two minutes. Follow next steps:
1. Insert USB Flash Drive with firmware procedure to USB Host
interface on the front panel of the oscilloscope.
2. Press the “UTILITY” button to enter the “Utility menu”.
3. Press “Next Page” option button to enter the third page of “Utility
menu”.
4. Press the “Update Firmware” option button.