Extron Electronics VN-COMMANDER - Manual (Page 84)

Section 3: Creating a Presentation VN-COMMANDER User Guide
74 I456GB issue 8
Adding or Changing Scene Commands
~
For the currently selected scene, click on the
button on the Scene Properties toolbar, or for any
scene right-click on the scene title in the Scene List.
The Scene Properties dialog will appear.
~
Click on the appropriate Scene Commands tab:
• •• • Pre
(as soon as the scene is selected but not yet
fully displayed);
• •• • Post
(when the scene display is fully complete);
• •• • Exit
(when another scene is selected but before the
Pre commands of the new scene).
NOTE: The method of adding, editing or removing commands
from each tab is the same.