Extron Electronics VN-COMMANDER - Manual (Page 13)

VN-COMMANDER User Guide Section 1: Getting Started
I456GB issue 8 3
Scene Control Each source is displayed in a fully resizable ‘window’,
allowing multiple sources to be placed in any position on
the display.
VN-COMMANDER uses ‘scenes’ to record different
source layouts on the display. Scenes can then be recalled
in any order using a customizable user interface or in a
pre-defined order at specific time intervals using the
built-in AutoPlay function.
Scenes can also be recalled remotely using via RS-232 (see
Appendix B) or Ethernet (consult Electrosonic for details).
C o n t r o l o f
External Devices
VN-COMMANDER can be set up to include commands
which are transmitted (over serial or Ethernet links) when
a particular scene or source is selected. These commands
can be used to provide automatic control of external
devices such as disc players or matrix switchers.
Hardware Requirements
Computer
Specification
To ensure that VN-COMMANDER functions correctly
and reliably, it must be installed on a computer that meets
or exceeds the following criteria:
Minimum Recommended
Operating System Windows NT4 (SP6) Windows 2000/ XP
Processor Speed 200MHz 450MHz or higher
Memory (RAM) 64MB 128MB or higher
Hard Disk Free Space 30MB >30MB
Graphics 1024x768, 65K colors (16-bit) 1024x768, 16.7M colors (32-bit)
Network Card (Ethernet) 10BASE-T 100BASE-T
These are the minimum requirements for VN-COMMANDER
only; if you intend running additional software applications,
these applications may require a higher specification.