Introduction – Extron Electronics VN-COMMANDER User Manual
Page 33
VN-COMMANDER User Guide
Section 2: System Configuration
I456GB issue 8
23
Introduction
There are four procedures or ‘tasks’ associated with
configuring VN-COMMANDER to work correctly with a
VN-QUANTUM Processor:
•
•
•
• Choosing a Display Processor
Used to establish communications with a
VN-QUANTUM. See page 24 for further details.
•
•
•
• Choose a Display Layout
Used to select the format of the target display and
assign screens to a VN-QUANTUM Processor.
See page 26 for further details.
•
•
•
• Communications Setup
Used to configure the computer’s serial ports (
e.g.
to
allow
remote
control of
VN-COMMANDER)
and/or
communication with external devices such as source
switchers. This task is also used to enable or disable
XML drivers. See page 38 for further details.
•
•
•
• Set Up Sources
Used to define the sources available to the
VN-QUANTUM. See page 43 for further details.
These tasks can be undertaken in any order, although the
order in which they are listed above is recommended.
Unless otherwise stated, all configuration settings described
in this section are saved in the presentation (.ctp) file.