Extron Electronics VN-COMMANDER - Manual (Page 5)

VN-COMMANDER User Guide Preface
I456GB issue 8 - iii -
Preface
About This User Guide This is a User Guide for the VN-COMMANDER and VN-
COMMANDER CONNECT software applications from
Electrosonic. This User guide provides information for the
following Electrosonic products
- VN-Quantum
- VN-Quantum Connect
To help you to quickly locate the information you require,
it is structured into four main sections:
• • • • Section 1: Getting Started — which explains how to
install the software and image processing hardware,
as well as introducing the user interface and some
basic ‘housekeeping’ procedures;
• • • • Section 2: System Configuration — which gives
details on setting up VN-COMMANDER to control
VN-QUANTUM image processing hardware;
• • • • Section 3: Creating a Presentation — which explains
how to manipulate sources on the target display;
• • • • Section 4: Viewing a Presentation — which explains
the different methods you can use to view a
VN-COMMANDER presentation;
• • • • Appendix A: IP Addressing — which briefly explains
what IP Addresses are and how to decide on suitable
addresses for your system.
• • • • Appendix B: Serial Commands — which gives advice on
the formatting and usage of serial data strings for
controlling serial switchers and other RS-232 devices.
• • • • Appendix C: Access Control — which describes the
built-in access control functionality, allowing different
users to have different access rights.
A summary contents list is provided at the start of each
section and a full contents list appears after this preface.