Extron Electronics VN-COMMANDER - Manual (Page 72)

Section 2: System Configuration VN-COMMANDER User Guide
62 I456GB issue 8
Id
The source input number on VN-QUANTUM
identified by the card slot number and card
input number,
e.g. 5.3 is the source connected to
input 3 of the card in slot 5.
This value can be entered manually or detected
by using the Detect Sources button (see Helpful
Hint on page 48).
Location
The IP address of the VN-QUANTUM card
frame where the source is connected.
This value can be entered manually or detected
by using the Detect Sources button (see Helpful
Hint on page 48).
Format
When AutoDetect is set to True this is a
read-only field that reports the source type as
detected by VN-QUANTUM.When AutoDetect
is set to False this is a drop-down list allowing
the manual selection of a source type.
AutoDetect
Set to True to allow VN-QUANTUM to
auto-detect the current source type.
Set to False to manually select the source type
using the Format drop down list.
Deinterlace
Sets the de-interlace mode to be applied to the
source. Choose between:
1i – Single Field Interpolation
3i – Three Field Interpolation
Refer to the VN-QUANTUM User Guide for
further advice on de-interlacing.
Critical*
When set to True the VN-QUANTUM will treat
this as a critical source (guaranteed to display
in real-time).
When set to False the VN-QUANTUM will
treat this as a non-critical source (fields may get
dropped if RAPT bandwidth is exceeded).
Input Auto: Auto discover format
SVideo: Force S-Videomode
Composite: Force Composite mode
Always on
False:
True:
* Initial firmware releases for VN-QUANTUM only support
the use of Critical sources.