Extron Electronics VN-COMMANDER User Manual
Page 70
Section 2: System Configuration
VN-COMMANDER User Guide
60
I456GB issue 8
Item
Control
Action
Source Name
Enter the name for the source.
Source ID
The slot and channel number of the RGB card
in the Quantum frame is listed.
Switch
setting
Source Location
The IP address of the Quantum frame is listed
Format
Only accessible when in ‘manual’ mode.
Lists the standard modes that are available.
Colour space
Select the required colour space
Auto detect
The format of the source that is connected to
the card is detected automatically.
Source
Format
Manual
When this mode is enabled, the input mode
may be forced to a known format.
In addition new ‘custom’ input modes may be
built. Note 1
Brightness, Contrast
Used to adjust the brightness and contrast of a
source.
Phase, Pixel clock
Used to adjust the sample clock parameters.
Note: ensure that ‘auto phase’ is not checked.
Adjustments
Auto phase
Checked: Automatically adjusts the clock
phase.
Un-checked: No auto clock phase adjust.
X, Y, H pos, V Pos
These controls allow a section of the captured
source to be isolated as a viewport. Note: only
one viewport for each input channel.
Source
Viewporting
Image Auto centre
Off: no auto centering
Once: the source image is centered as part of
the detect process.
Continuous: the input source is continually
monitored and centered.
Checked
The source is displayed in the current scene
Keep scene
Un-checked
The source is displayed on Quantum output
1,1.
Note1: For a more detailed description of these controls, please contact
Electrosonic for an application note.