Extron Electronics VN-COMMANDER - Manual (Page 76)

Section 2: System Configuration VN-COMMANDER User Guide
66 I456GB issue 8
Trimming
Sets how the date/time text string is treated
when the window is smaller that the text.
None: no trimming - the text is truncated.
Character (default): the string is broken at the
boundary of the last character that is inside the
layout rectangle.
Word: the string is broken at the boundary of
the last word that is inside the window.
Ellipsis Character: the string is broken at the
boundary of the last character that is inside the
window and an ellipsis (...) is inserted after the
character.
Ellipsis Word: the string is broken at the
boundary of the last word that is inside the
window and an ellipsis (...) is inserted after the
word.
Ellipsis Path: the center is removed from the
string and replaced by an ellipsis. This keeps as
much of the last portion of the string as possible
TimerCount When using Timer mode, use this parameter to
Direction set the direction that the timer will count from:
Up (default)
Down
Cmd
A command to control timer operation. Thee
commands are supported: Start, Stop and
Reset.
For more details on how to change these
commands on-the-fly, contact Electrosonic
Product Support.
Note: A left-click on the timer window in the Scene
Design task simulates a Start/Stop command; a
right-click simulates a Reset command.
VN-COMMANDER CONNECT does not support the
use of Clock or Timer sources.