Extron Electronics VN-COMMANDER User Manual

Page 35

VN-COMMANDER User Guide

Section 2: System Configuration

I456GB issue 8

To connect to a VN-QUANTUM Processor...

Select (i.e. check) the Connect checkbox for the appropriate processor:

If you are using more than one processor, you need to ‘connect’ to each
processor in this way.

NOTE:

If the checkbox does not stay selected, this indicates that VN-

COMMANDER is unable to establish or maintain a connection (e.g. due to a
faulty cable).

To disconnect from a VN-QUANTUM Processor...

Deselect (i.e. uncheck) the Connect checkbox for the appropriate processor:

To assign a Name to a VN-QUANTUM Processor...

If you are using VN-COMMANDER to control more than one processor, you
may find it helpful to give a name to each processor that more easily identifies
its role within the system. This will be especially useful when assigning processors
to the target display screens.

For example, if you are using two processors driving the left-hand and right-
hand sides of the target display respectively, you could name them ‘Left’ and
‘Right.

Click on the Name box for the appropriate processor, then type in a suitable

name:

VN-COMMANDER CONNECT does not support the
use of multiple processors.