Extron Electronics VN-COMMANDER - Manual (Page 27)

VN-COMMANDER User Guide Section 1: Getting Started
I456GB issue 8 17
Starting a New Presentation
When you run VN-COMMANDER for the first time after
installation, a new ‘untitled’ presentation will be created with
no system configuration settings.
Thereafter, there are two methods of starting a new ‘untitled’
presentation depending on whether you want to:
• retain the existing system configuration (e.g. to make a new
presentation for the same system), or to
• create a completely new presentation with no system
configuration (e.g. to make a new presentation for a
different system).
To Retain the Existing
System Configuration
~
Click the button on the main toolbar.
You can also choose File | New from the menu bar or press Ctrl +
N on the keyboard.
To Create a
Completely New
Presentation
Exit VN-COMMANDER by following the instructions
on page 14.
While holding down the keyboard SHIFT key, run VN-
COMMANDER by following the instructions on page 14.
Once the VN-COMMANDER application window has appeared,
you can release the SHIFT key.
• To give your ‘untitled’ presentation a name, you need to
save it as described on page 18.
• If you are creating a presentation for a new system or
need to make changes to the existing configuration, refer
to Section 2: System Configuration.
• To start putting sources on the target display, turn to
Section 3: Creating a Presentation