Extron Electronics VN-COMMANDER - Manual (Page 127)

Section 4: Viewing a Presentation VN-COMMANDER User Guide
I456GB issue 8 117
Changing the Playback Speed
When using AutoPlay, the time that each scene is
displayed is controlled by the AutoPlay Delay setting in
the Scene Properties dialog box (see page 115).
However, it is possible to speed up or slow down the rate
of display across the whole presentation.
~
To change the playback speed, you need to use the
following buttons on the Scene Properties toolbar:
To... Click on...
Increase the
playback speed
the button.
Each click decreases the normal
delay time* of each scene by 10%,
thus increasing the playback speed.
Decrease the
playback speed
the
Each click
delay time*
thus decreasing
button.
increases the normal
of each scene by 10%,
the playback speed.
* The normal delay time is that defined by the AutoPlay
Delay value in the Scene Properties dialog.
The current AutoPlay time adjustment is displayed on the
status bar, with normal speed being 100%. For example: