Extron Electronics SMD 101 User Guide - Manual (Page 86)

Command
ASCII Command
(host to unit) Response
(unit to host)
Additional Description
Outputs
Video
Set video output
format
E X3^VTPO} Vtpo X3^]
View video output
format
E VTPO} X3^]
View output rate E RATE} X52! ]
Set output rate E X52!RATE} Rate X52!]
Mute all outputs to
black
1B Vmt1]
Mute all sync and
video
2B Vmt2]
Unmute all outputs 0B Vmt0]
View B X54@
Test pattern
Select test pattern E X52@ TEST} Test X52@ ] Set the test pattern to X52@ .
View E TEST } X52@ ] View the current test
pattern.
Audio
Set dual mono E o1AFMT} Afmto1]
Set stereo E o2AFMT} Afmto2]
View audio output
format
E oAFMT} X55! ]
Set volume X55)V} Vol X55)] Set analog volume to X55) .
Increment volume +V} Vol X55)] Increment analog audio
volume up by 1 dB.
Decrement volume ‑V} Vol X55)] Decrement analog audio
volume down by 1 dB.
View volume V} X55) ] View the analog output
volume.
Mute on 1Z Amt1] Mutes selected audio
channel.
Mute off 0Z Amt0] Unmutes selected audio
channel.
View audio mute
status
Z X51)] 0=Mute off
1=Mute on.
Command and Response Table for Player SIS Commands (continued)
NOTES:
X3^ = HDMI output format See HDMI output format table on page 64 .
X51) = Enable or disable 0=Mute off/disabled
1=Mute on/enabled
X52! = Video output rate See video output rate table on page 64 .
X52@ = Test pattern See test pattern selection table on page 65 .
X54@ = Video mute 0=Unmute all
1=Mute to black
2=Mute video and sync
X55) = Audio volume 0 to -100 dB in 1 dB steps
‑30=default
‑100=mute
X55! = Analog audio format 1=Dual mono
2=Stereo (default)
80 SMD 101 • Remote Communication and Control