Extron Electronics SMD 101 User Guide - Manual (Page 18)

SMD 101 Rear Panel Reset
The Reset button on the rear panel of the SMD 101 (see Figure 3 on page 9) returns the
SMD 101 to various modes of operation.
To select different reset modes, use a pointed stylus or small screwdriver to press and hold
the Reset button while the SMD 101 is powered, or press and hold the Reset button while
applying power to the SMD 101.
ATTENTION: Review the reset modes carefully. Some reset modes delete all
user loaded content and revert the device to default configuration. The SMD 101
Reset Summary on page 83 provides a summary of the reset modes and the
configuration settings affected by each mode.
NOTES:
• The reset modes close all open IP and Telnet connections and all sockets.
• Each reset mode is a separate reset (not a continuation from mode 1 to mode 5).
• Reset modes 2 and 3 are not available for the SMD 101.
• The SMD 101 can also be reset using the web-based user interface (see Reset
Device on page 42).
• For information on resetting the SMD 101 using SIS commands, see Resets on
page 68 of the Command and Response Tables section.
• Further details comparing the reset modes and affected configuration settings
and user content are in the reference section (see
SMD 101 Reset Summary on
page 83).
RESET RESET
RESET RESET RESET
Release, then immediately
press and release again. Reset
LED flashes, then goes off. Modes 4 and 5
Press and hold
the Reset button.
Mode 1
Reset LED flashes
twice or three times.
Press and hold for
6 or 9 seconds.
Apply power
to the SMD 101.
Release Reset button.
Figure 9. Resetting the SMD 101
SMD 101 • Panels and Cabling 12