Extron Electronics SMD 101 User Guide User Manual
Page 41
•
MAC
Address:
— The MAC address of the connected SMD 101. The address is also
available on the rear panel label.
•
Reset
to
Default:
— Resets all network configuration to default.
•
Save
— Saves manual network configuration changes.
•
Cancel
— Discards manual network configuration changes.
NOTES:
•
The DHCP assigned Gateway and DNS address are retained after DHCP is
deselected. They are reset using the reset button on the rear panel (see
on page 12) or using the web-based user interface (see
•
The network interface restarts when changes are saved.
Ethernet Diagnostics panel
This panel provides a ping utility for troubleshooting network connection issues.
•
Address
to
ping:
— Enter an IP address (10.13.193.168) or a complete host name
(www.extron.com) in this field, then click
Ping
to start the utility. A dialog box with the
results of the ping opens.
192.168.3.51
www.extron.com
Figure 32.
Network Ping Dialog
Network Port Mapping panel
This panel provides basic Ethernet configuration that includes:
•
SFTP:
— Set the port number for SFTP here. Check
Enable
to use the port.
•
SIS
(SSH):
— SSH provides a method for a SSH client to establish a secure
connection to the player at port 22023, which then supports the SIS command set.
•
Telnet
(Extron
SIS):
— The port used by DataViewer or other telnet programs to
access the SMD 101. Check
Enable
to use the port.
•
HTTP:
— Set the port number for HTTP here. Check
Enable
to use the port.
•
SNMP:
— Set the port number for SNMP here. Check
Enable
to use the port.
•
HTTPS/SSL:
— Set the port number for HTTPS here. Check
Enable
to use the port.
NOTE: Changing or disabling this port while using the default port (80) causes a
loss of the connection. Try https://
•
Serial
Pass
-
through:
— Set the port number for the serial pass-through feature
here. Check
Enable
to use the port.
•
Reset
to
Default
— Click to return all port mappings to default.
Default port numbers are shown in
on the previous page. Click the checkbox after
the port number field to enable the port entry in the associated port field. Click
Reset
to
return the port number to default.
SMD 101 • Web-based User Interface
35