Extron Electronics SMD 101 User Guide User Manual
Page 77
Command
ASCII Command
(host to unit)
Response
(unit to host)
Additional Description
IP Setup Commands
Set unit name
E X1@ CN }
Ipn
•
X1@ ]
Set the name of the unit.
Set unit name to
factory default
E
•
CN }
Ipn
•
X1@ ]
Sets the name of the unit to the
factory default.
View unit name
E CN }
X1@ ]
View the name of the unit.
Set date / time
E MM/DD/YY‑
HH:MM:SS CT }
Ipt
•
X1# ]
Set the date and time.
View date / time
E CT }
X1# ]
View the date and time.
Set time zone
E X60( * TZON }
Tzon X60( * X61) ]
View time zone
E TZON }
Tzon X60(* X61) ]
View all time zones
E * TZON }
Tzon X60(* X61) ]...
Repeats for all time zones.
Set DHCP on
E 1DH }
Idh1 ]
Sets DHCP to on.
Set DHCP off
E 0DH }
Idh0 ]
Sets DHCP to off.
View DHCP mode
E DH }
X% ]
View the DHCP mode setting.
Set IP address
E X1$ CI }
Ipi
•
X1$ ]
Set the IP address of the unit.
View IP address
E CI }
X1$ ]
View the IP address of the unit.
View hardware MAC
address
E CH }
X1* ]
In verbose mode:
Iph
•
X1* ]
View the hardware MAC
address of the unit.
Set subnet mask
E X1( CS }
Ips
•
X1( ]
Set the subnet mask of the
unit.
View subnet mask
E CS }
X1( ]
View the subnet mask of the
unit.
Set gateway IP
address
E X1% CG }
Ipg
•
X1% ]
Set the gateway IP address.
View gateway IP
address
E CG }
X1% ]
View the gateway IP address.
NOTES:
X% = DHCP mode
0 = Off, 1 = On
X1@ = Unit/Device/Network Host Name
63 characters, maximum. Must comply with internet host name
standards. See RFC1123.
X1# = Day, date, and time
Format: Day, DD Mmm YYYY HH : MM : SS
X1$ = IP address (xxx.xxx.xxx.xxx)
Default IP address = 192.168.254.254
X1% = Gateway address
Default gateway IP address = 0.0.0.0
X1* = Hardware MAC address
00‑05‑A6‑xx‑xx‑xx
X1( = Subnet mask
Default subnet mask = 255.255.0.0
X60(
= Time zone location
2-6 letters (typically 3)
X61)
= Time zone description
Example: (UTC‑08:00) Pacific Time
Command and Response Table for Basic SIS Commands (continued)
71
SMD 101 • Remote Communication and Control