GE Industrial Solutions Entellisys 4.0 Integrator's Guide User Manual
GE Industrial Solutions Equipment
Table of contents
Document Outline
- Contents
- Integrator’s Guide
- 1.1 PLC support
- 1.1.1 PLC Input
- 1.1.2 FlexLogic Operand States
- 1.1.2.1 Breaker Control Flex Operand States
- 1.1.2.2 Bus Differential Flex Operand States
- 1.1.2.3 Ground Fault Flex Operand States
- 1.1.2.4 High Current and High Current Transient Flex Operand States
- 1.1.2.5 HRGF Detection Flex Operand States
- 1.1.2.6 HRGF Location Flex Operand States
- 1.1.2.7 IOC Flex Operand States
- 1.1.2.8 LT Overcurrent Flex Operand States
- 1.1.2.9 MSGF Overcurrent Flex Operand States
- 1.1.2.10 Multi Point RELT Flex Operand States
- 1.1.2.11 Over (and Under) Frequency Flex Operand States
- 1.1.2.12 Over (and Under) Voltage Flex Operand States
- 1.1.2.13 Phase Loss Flex Operand States
- 1.1.2.14 Power Reversal Flex Operand States
- 1.1.2.15 ST Overcurrent Flex Operand States
- 1.1.2.16 Summation MSGF Zone Flex Operand States
- 1.1.2.17 Synch Check Flex Operand States
- 1.1 PLC support
- Modbus® protocol implementation
- 2.1 Introduction
- 2.2 Physical layer
- 2.3 Data link layer
- 2.4 CRC-16 Algorithm
- 2.5 Supported function codes
- 2.6 Interfacing to the Alarm Handler
- Modbus Memory Map
- Modbus Memory Map Format Codes