SENA ProBee-ZE20S-SEME - Manual (Page 87)

ProBee-ZE20S-SExx User Guide Rev 1.8 87
7.8.2 AT+NWKKEY or AT+NK
Description Get/Set the 128-bit network key. (0 or 0s: generate random 128-bit number)
Execute AT+NWKKEY? AT+NWKKEY=
Response
OK
OK or ERROR
Default FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF
7.8.3 AT+UPDATEKEY or AT+UK
Description
Update the network key with a new generated key. (possible only for coordinator)
It is applied after 30s later because sending too quickly may cause a sleepy end-
device to miss the alternate encryption key and only get the switch key message,
which means it will be unable to change to the new network key.
Execute AT+UPDATEKEY
Response OK or ERROR
7.8.4 AT+KEYTABLE or AT+KT
Description Get/Set/Remove link key table.
Execute
AT+KEYTABLE?
R>
AT+KEYTABLE=,
address>,
key>
AT+KEYTABLE=
Response
table>
OK or
ERROR
KEY TABLE
REMOVED
OK or ERROR
7.9 UART
7.9.1 AT+BAUDRATE or AT+UB
Description
Get/Set the serial port speed for communication between the module serial port
and host.
Execute AT+BAUDRATE? AT+BAUDRATE=
Response
OK
OK or ERROR
Default 9600
Range 300 – 230400
7.9.2 AT+DATABIT or AT+UD
Description Get/Set the serial data bit setting on the module.
Execute AT+DATABIT? AT+DATABIT=