SENA ProBee-ZE20S-SEME User Manual
Page 5
ProBee-ZE20S-SExx User Guide Rev 1.8
5
3.4.2
Node Type Selection for Coordinator ........................................................................................ 31
3.4.3
Channel Mask Configuration for Coordinator ........................................................................... 31
3.4.4
PAN ID Configuration for Coordinator ....................................................................................... 32
3.4.5
Permit Joining.............................................................................................................................. 32
3.4.6
Add Pre-configured Link Key to Key Table ............................................................................... 33
3.5
Setting up ZE20S as a Router ........................................................................................................... 34
3.5.1
CBKE Data Token Configuration ............................................................................................... 34
3.5.2
Install Code Configuration .......................................................................................................... 35
3.5.3
Node Type Selection for Router ................................................................................................. 35
3.5.4
Channel Mask Configuration for Router .................................................................................... 35
3.5.5
PAN ID Configuration for Router ................................................................................................ 35
3.5.6
Permit Joining.............................................................................................................................. 36
3.6
Setting up ZE20S as an End-Device ................................................................................................ 36
3.7
Setting up ZE20S as a Sleepy End-Device ...................................................................................... 37
3.8
Starting Key Establishment ................................................................................................................ 39
3.9
Frequency Agility ................................................................................................................................ 40
4
DIGITAL AND ANALOG I/O.................................................................................... 41
4.1
GPIO (General Purpose Inputs and Outputs) Configuration ........................................................... 41
5
WORKING WITH DEVELOPMENT KIT ................................................................. 43
5.1
Development Kit Contents ................................................................................................................. 43
5.2
Development Board Features ............................................................................................................ 43
5.3
Development Board Hardware Descriptions .................................................................................... 44
5.3.1
Power ........................................................................................................................................... 44
5.3.2
RS232 Port .................................................................................................................................. 44
5.3.3
USB Port ...................................................................................................................................... 45
5.3.4
ZE20S GPIO Interface ................................................................................................................ 45
5.3.5
LEDs (CR12-19).......................................................................................................................... 46
5.3.6
Button Switches (SW10-17) ....................................................................................................... 46
5.3.7
Variable Resistors (VR1, VR2)................................................................................................... 46
5.3.8
Temperature Sensor ................................................................................................................... 46
5.3.9
Light Sensor ................................................................................................................................ 46
5.3.10 Terminal Block ............................................................................................................................. 47
5.4
Configuration Example: 1 Coordinator and 2 End-Devices ............................................................. 47
5.4.1
CBKE Data Token Configuration ............................................................................................... 48
5.4.2
Install Code Configuration .......................................................................................................... 54
5.4.3
ProBeeSESI Coordinator Configuration .................................................................................... 55
5.4.4
ProBeeSEID End-device Configuration .................................................................................... 55
5.4.5
ProBeeSEME End-device Configuration ................................................................................... 57