Rainbow Electronics AT75C220 - Manual (Page 68)

AT75C220
68
PIO Status Register
Register Name:PIO_PSR
Access Type:Read-only
This register indicates which pins are enabled for PIO control. This register is updated when PIO lines are enabled or dis-
abled.
1 = PIO is active on the corresponding line (peripheral is inactive).
0 = PIO is inactive on the corresponding line (peripheral is active).
PIO Output Enable Register
Register Name:PIO_OER
Access Type:Write-only
This register is used to enable PIO output drivers. If the pin is driven by a peripheral, there is no effect on the pin but the
information is stored. The register is programmed as follows:
1 = Enables the PIO output on the corresponding pin.
0 = No effect.
31 30 29 28 27 26 25 24
P31 P30 P29 P28 P27 P26 P25 P24
23 22 21 20 19 18 17 16
P23 P22 P21 P20 P19 P18 P17 P16
15 14 13 12 11 10 9 8
P15 P14 P13 P12 P11 P10 P9 P8
7 6 5 4 3 2 1 0
P7 P6 P5 P4 P3 P2 P1 P0
31 30 29 28 27 26 25 24
P31 P30 P29 P28 P27 P26 P25 P24
23 22 21 20 19 18 17 16
P23 P22 P21 P20 P19 P18 P17 P16
15 14 13 12 11 10 9 8
P15 P14 P13 P12 P11 P10 P9 P8
7 6 5 4 3 2 1 0
P7 P6 P5 P4 P3 P2 P1 P0